Guido Kimble

Where does the tubes organizer connect? My back panel doesn't look like the one pictured. Mine has no grille area, the circuit board mounts near the top of the machine not the bottom, it has only one small slot that looks like it's for the organizer, etc.).

Do you have files for the little 3D printed tube tags?

Add a picture showing the pump, amd labeling one port "INLET", and the other "OUTLET". Talking about "right" and "left" on cylindrical parts doesn't mean anything... "left if the white housing is facing me, tubes up?", or "left if the white housing is facing me, tubes down", or if the white housing is facing away, etc?

It would be good to attach the hoses to the pour spouts now, because chasing the tubes down on the housing is tough.

Since half the pumps face each way, it would be helpful to have a picture of which side is "left" or "right", and which way which tubes go.

Screws require #1 Phillips screwdriver tip (not standard #2).

My screws are brass.

This could have been done earlier, before installing the panel.

I put this in upside down. My fault, for not noticing the pictures flipped, but these parts could be designed to only be assembled one way (the correct way).

The center-to-center hole distance is the same on the two 3D printed parts (19.9mm, measured with calipers), but drastically different on the sensor circuit board (21.1mm). There is no way to attach the sensor without modification (DO NOT enlarge the sensor board holes... there are circuit traces very close to the holes).