Skip to main content

Site Navigation

Your Account

Choose Language

  1. Acrylic front
    • Acrylic front

    • Wire

    • Distance sensor

    • Screws M3 4mm (Black) (2x)

    • Sensor holder front (3d Printed)

    • Sensor holder back (3d Printed)

  2. Remove the protective paper from the acrylic. Insert the sensor holder front from the side of the acrylic without the protective paper. Turn the acrylic around and position the sensor holder back aligned with the holes for the screws on the sensor holder front.
    • Remove the protective paper from the acrylic.

    • Insert the sensor holder front from the side of the acrylic without the protective paper.

    • Turn the acrylic around and position the sensor holder back aligned with the holes for the screws on the sensor holder front.

    • Position the distance sensor on top of the sensor holder back and align the holes for the screws.

    • Inset and tight the screws.

    • Connect the wire with the red wire starting all the way on the left of the distance sensor.

  3. Insert M3 Nuts (2x) in the case. Position the acrylic front in the case with the sensor facing out.
    • Insert M3 Nuts (2x) in the case.

    • Position the acrylic front in the case with the sensor facing out.

    • Inset and tight the M3 8mm screws (Black) (2x)

  4. Case
    • Case

    • LED holder, Nut and Washer

    • LED + Wire

  5. Remove the Nut from the LED Holder. Insert the LED Holder with the Washer in the case, from the bottom of the "Top front bottom panel" smaller hole.
    • Remove the Nut from the LED Holder.

    • Insert the LED Holder with the Washer in the case, from the bottom of the "Top front bottom panel" smaller hole.

    • Secure the LED Holder using the Nut.

    • Insert the LED in the LED holder it it isn't already in.

  6. Great job! How about 4. Pumps column assembly?
Finish Line

mybar.io

Member since: 03/18/2019

362 Reputation

6 Guides authored

0 Comments

Add Comment