dannyboychicago

Suggest clarifying that the orientation to select the correct right tube to mark is when viewing the pump from that the wires side forward, not the back smooth part of the pump. I made that mistake and had to reverse everything out after closing the case.

Would also add to be very careful to not pull too hard on the distance sensor wires in particular when fishing them through the column hole, into the case, and then ultimately into the PCB. A tug too hard and some soldering repair might be required :-(

Suggest adding a step to do one cleaning cycle at this point before putting on the top cover. Will save some effort to confirm the MyBar is working correctly, and then if necessary it’s easier to do the required re-wiring, or adjustment of tubes before putting on top cover.

Current version of the kit (as of July 12, 2021) there is not a discernible difference in the length of the tubes - am I correct in that observation?