Skip to main content
  1. Tubes Holder (Back)
    • Tubes Holder (Back)

    • Silicone Tube Connectors (9x)

    • Silicone Tubing 36in (9x)

  2. Insert the Tubes Holder (Back) into the back panel. Insert the Silicone Tube Connectors inside Silicone Tubing 36in (9x). Insert the other end of the Silicone Tube Connectors into the Tubes Holder (Back).
    • Insert the Tubes Holder (Back) into the back panel.

    • Insert the Silicone Tube Connectors inside Silicone Tubing 36in (9x).

    • Insert the other end of the Silicone Tube Connectors into the Tubes Holder (Back).

  3. Connect the Back Silicone Tubes coming from the motors  to the matching number on the Tubes Holder (Back). Connect the Back Silicone Tubes coming from the motors  to the matching number on the Tubes Holder (Back).
    • Connect the Back Silicone Tubes coming from the motors to the matching number on the Tubes Holder (Back).

  4. Connect the distance sensor according to the image. Connect the LED according to the image.
    • Connect the distance sensor according to the image.

    • Connect the LED according to the image.

    • Connect pumps 1 to 9 starting with pump number 1 on the left according to the image.

    • Close the Back panel.

  5. Tubes Holder (Front) Install the LED holder in the center hole.
    • Tubes Holder (Front)

    • Install the LED holder in the center hole.

  6. Tubes Holder (Front) Insert the Tubes Holder (Front) into the Top front bottom panel and rotate slightly until it locks in place. Insert the LED in the LED holder.
    • Tubes Holder (Front)

    • Insert the Tubes Holder (Front) into the Top front bottom panel and rotate slightly until it locks in place.

    • Insert the LED in the LED holder.

    • Connect the Front Silicone Tubes coming from the motors, in any order, to the Tubes Holder (Front).

  7. Top panel
    • Top panel

    • Screws M3 10mm (Black) (2x)

    • M3 Nuts (2x)

  8. Take the case and insert two M3 nuts. Connect the case with the Top panel.
    • Take the case and insert two M3 nuts.

    • Connect the case with the Top panel.

    • Insert the M3 10mm screws through both holes on the top. Start tightening until you reach the M3 nut. Tighten both screws all the way.

  9. Insert the Tubes Organizer into the Back panel. Insert the Tubes Organizer into the Back panel. Insert the Tubes Organizer into the Back panel.
    • Insert the Tubes Organizer into the Back panel.

  10. It's time for a cocktail! Don't forget to download the mobile app.
    • It's time for a cocktail! Don't forget to download the mobile app.

Finish Line

One other person completed this guide.

MyBar.io

Member since: 03/18/2019

650 Reputation

7 Guides authored

0 Comments

Add Comment