Skip to main content
  1. Back panel
    • Back panel

    • Spacers M3 6mm (4x)

    • Screws M3 4mm (Black) (4x)

  2. Insert the spacers on the back panel. Using the M3 4mm screws mount the circuit board to the spacers.
    • Insert the spacers on the back panel.

    • Using the M3 4mm screws mount the circuit board to the spacers.

  3. Power Jack
    • Power Jack

    • Power Jack holder

  4. Insert the washer into the power jack. Insert the power jack (with the washer) from the back of the holder and secure it with the nut.
    • Insert the washer into the power jack.

    • Insert the power jack (with the washer) from the back of the holder and secure it with the nut.

    • Insert the power jack holder into the back panel

    • Connect the power wire to the circuit board

  5. Perfect! Electronics ready. Next, lets start with the 3. Case assembly
Finish Line

One other person completed this guide.

MyBar.io

Member since: 03/18/2019

650 Reputation

7 Guides authored

One Comment

Should have link to next step at end.

Dave@innonavi.com - Reply

Add Comment